2,718
edits
Changes
Jump to navigation
Jump to search
Line 150:
Line 150: − +
Building a Zynthian Box using an official Kit (view source)
Revision as of 12:45, 17 January 2017
, 12:45, 17 January 2017→Assembling the Controller Modules
1. Bend the encoder's securing tabs to 90º, so you can insert it in the upside of the PCB (the labeled side!).
1. Bend the encoder's securing tabs to 90º, so you can insert it in the upside of the PCB (the labeled side!).
2. Place the capacitor in the C1 position (the most right!)
2. Place the capacitor in the C1 position (the most right!)
3. Solder the encoder and capacitor carefully. Always avoid overheating!
3. Solder the encoder and capacitor carefully. Avoid overheating! => [[#Some_general_recommendations|Read this!]]
4. Place the pin-row connector in the downside of the PCB, with the angle pins facing inwards (look the photo!)
4. Place the pin-row connector in the downside of the PCB, with the angle pins facing inwards (look the photo!)
5. Solder the pin-row carefully.
5. Solder the pin-row carefully.