2,718
edits
Changes
Jump to navigation
Jump to search
Line 521:
Line 521: − + + + + + + + + + + + + + + + + + + +
→Step 14: Plug the control ribbon cable into the main board
<br clear=all>
<br clear=all>
=='''Step 14: Plug the control ribbon cable into the main board'''==
=='''Step 14: Plug the control flat cable into the main board'''==
<br clear=all>
[[File:capture000106_fixed_wiki.jpg|600px|right]]
'''1.''' Place the two parts one aside the other, forming 90º angle, as shown in the picture.
<br clear=all>
[[File:capture000109_fixed_wiki.jpg|600px|right]]
'''2.''' Using two fingers, one each hand, softly pull the display's FPC tongue until it's open. Insert the flat ribbon cable coming from the RPi4 in the bottom's part. Do it straight, without bending or twisting it in any way.
<br clear=all>
[[File:capture000110_fixed_wiki.jpg|600px|right]]
'''3.''' When it's totally inserted, softly push the tongue using 2 fingers, one each hand, until it's totally closed. Put attention to the cable not moving out the connector. If it's not well inserted or not straight, repeat the operation until it's OK.
<br clear=all>
<br clear=all>