2,718
edits
Changes
→Step 9: Secure the top-spacers on the control board
'''1.''' Take the control board from its case. You don't need the silicone buttons yet.
'''1.''' Take the control board from its case. You don't need the silicone buttons yet.
<br clear=all>
[[File:capture000090_fixed_wiki.JPG|600px|right]]
'''2.''' If you don't want your zynthian V5 behaves like a snare, please, remove the nuts and rings from the rotary encoders.
<br clear=all>
<br clear=all>
[[File:capture000071_fixed_wiki.JPG|600px|right]]
[[File:capture000071_fixed_wiki.JPG|600px|right]]
'''2.''' Take the 8 x brass spacers 10mm and 8 x ISO7380 M3 screws (the mid-size ones with round head).
'''3.''' Take the 8 x brass spacers 10mm and 8 x ISO7380 M3 screws (the mid-size ones with round head).
<br clear=all>
<br clear=all>
[[File:capture000068_fixed_wiki.JPG|600px|right]]
[[File:capture000068_fixed_wiki.JPG|600px|right]]
'''3.''' Secure the 8 x spacers in the control board's top side. For doing this, insert the bolt from the back side and while holding it with your finger, fasten the spacer with the other hand until it's tight. You don't need a wrench for this, but you could use it if you like.
'''4.''' Secure the 8 x spacers in the control board's top side. For doing this, insert the bolt from the back side and while holding it with your finger, fasten the spacer with the other hand until it's tight. You don't need a wrench for this, but you could use it if you like.
<br clear=all>
<br clear=all>