Changes

Jump to navigation Jump to search
Line 186: Line 186:  
===Encoder Pins===
 
===Encoder Pins===
 
Each zynthian encoder is connected to a minimum of 4 wires.
 
Each zynthian encoder is connected to a minimum of 4 wires.
1/ A wire connected to Ground or 0 Volts of the system. THis is what the other encoder wires connect to to inform the MC23017 that the pin is set logic low and should be interpreted as such.Do not worry that there is no logic high connection, this is indicated by an open circuit and by the clever use of Pull Up Resistors the open circuit connection can be interpreted as a logic High. If you have an encoder with a +V connection there are separate notes on how to address this as it is a little more complicated.
+
 
 +
==== A Ground Wire====
 +
 
 +
A wire connected to Ground or 0 Volts of the system. This is what the other encoder wires connect to to inform the MC23017 that the pin is set logic low and should be interpreted as such.Do not worry that there is no logic high connection, this is indicated by an open circuit and by the clever use of Pull Up Resistors the open circuit connection can be interpreted as a logic High. If you have an encoder with a +V connection there are separate notes on how to address this as it is a little more complicated.
    
So the encoder pins and the push down switch connect to 0V when operated.  
 
So the encoder pins and the push down switch connect to 0V when operated.  
1,019

edits

Navigation menu