Line 372:
Line 372:
The Pin that is connected to the Pi edge connector is connected to a range of GPIO Pins that are not in any particular order, and these are subsequently wired to the pins on the BCM processor that does all this work and they have ANOTHER Mapping which the zynthian references. It's done that way to make it processor based not Pi based. There are two settings in software that works on the machine that decides which particular addressing mode is being used.
The Pin that is connected to the Pi edge connector is connected to a range of GPIO Pins that are not in any particular order, and these are subsequently wired to the pins on the BCM processor that does all this work and they have ANOTHER Mapping which the zynthian references. It's done that way to make it processor based not Pi based. There are two settings in software that works on the machine that decides which particular addressing mode is being used.
−
The appropriate pins for the Raspberry Pi pins are listed in the webconf columns.
+
The appropriate pins for the Raspberry Pi pins are listed in the webconf columns.
+
+
[[File:Zynthian-amp3-open.jpg|300px|frame|center|Zynthian-amp3-open]]
=====Some settings that have been proved to work=====
=====Some settings that have been proved to work=====