1,023
edits
Changes
Jump to navigation
Jump to search
→Addressing
Line 257:
Line 257:
So the ordering of the Encoders in the Webconf is
−Ch, Back, Ls, Select…
=====Addressing=====
=====Addressing=====
−The Software itself needs to be informed of the correct pins to examine to see the behavior it is expecting. Encoder going up and down and switches being pressed, and obviously the machine has no way of telling which encoder is which.
The Software itself needs to be informed of the correct pins to examine to see the behavior it is expecting. Encoder going up and down and switches being pressed, and obviously the machine has no way of telling which encoder is which.
Line 265:
Line 263:
[[File:Zynthian-GPIO-encoders-amp3.png|300px|frame|center|Zynthian GPIO setting]]
[[File:Zynthian-GPIO-encoders-amp3.png|300px|frame|center|Zynthian GPIO setting]]
+
+The ordering of the Encoders in the Webconf is
+
+Ch, Back, Ls, Select… So a V4 implementation ( Two encoders either side of the touchscreen) would look something like this. . .
+
+[[File:Zynthian-amp3.jpg|300px|frame|center|zynthian-amp3]]
+
+
+Just to prove it can be done on GPIO pins here it is in all it's glory.
+
+[[File:Zynthian-amp3-open.jpg|300px|frame|center|Zynthian-amp3-open]]
==Encoders connected using a MCP23017 chip==
==Encoders connected using a MCP23017 chip==