Changes

<br clear=all>

<br clear=all>

[[File:capture000113_fixed_wiki.jpg|600px|right]]

[[File:build51_join_parts_control_01.jpg|600px|right]]

[[File:build51_join_parts_control_02.jpg|600px|right]]

'''1.''' Rotate the top part until it's parallel to the bottom part, as shown in the picture.

'''1.''' Rotate the top part until it's parallel to the bottom part, as shown in the picture.

<br clear=all>

<br clear=all>

[[File:capture000114_fixed_wiki.jpg|600px|right]]

[[File:build51_join_parts_control_03.jpg|600px|right]]

[[File:capture000115_fixed_wiki.jpg|600px|right]]

[[File:build51_join_parts_control_04.jpg|600px|right]]

'''2.''' Using two fingers, one on each hand, softly pull the main board's control-1 connector tongue until it's open. Insert the flat ribbon cable coming from the control board (top part). Do it straight, without bending or twisting it in any way, so the blue side is face down.

'''2.''' Using two fingers, one on each hand, softly pull the main board's control-1 connector tongue until it's open. Insert the flat ribbon cable coming from the control board (top part). Do it straight, without bending or twisting it in any way, so the blue side is face down.

<br clear=all>

<br clear=all>

[[File:capture000116_fixed_wiki.jpg|600px|right]]

[[File:build51_join_parts_control_05.jpg|600px|right]]

'''3.''' When it's totally inserted, softly push the tongue using 2 fingers, one on each hand, until it's totally closed. Pay attention to ensure the cable does not move out of the connector. If it's not well inserted or not straight, repeat the operation until it's OK.

'''3.''' When it's totally inserted, softly push the tongue using 2 fingers, one on each hand, until it's totally closed. Pay attention to ensure the cable does not move out of the connector. If it's not well inserted or not straight, repeat the operation until it's OK.