3,418
edits
Changes
Jump to navigation
Jump to search
Line 329:
Line 329: − + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + +
→Step 8: Assemble the display on the control board
<br clear=all>
<br clear=all>
=='''Step 8: Assemble the display on the control board'''==
=='''Step 8: Secure the top-spacers on the control board'''==
<br clear=all>
[[File:capture000060_fixed_wiki.JPG|400px|right]]
'''1.''' Take the control board from its case. You don't need the silicone buttons yet.
<br clear=all>
[[File:capture000071_fixed_wiki.JPG|400px|right]]
'''2.''' Take the 8 x brass spacers 10mm and 8 x ISO M3 screws (the mid-size ones with round head).
<br clear=all>
[[File:capture000068_fixed_wiki.JPG|400px|right]]
'''3.''' Secure the 8 x spacers in the control board's top side. For doing this, insert the bolt from the back side and while holding it with your finger, fasten the spacer until it's tight.
<br clear=all>
=='''Step 9: Assemble the display on the control board'''==
<br clear=all>
[[File:capture000072_fixed_wiki.JPG|400px|right]]
'''1.''' Take the display from its case and remove the 4 yellow protective sheets from the more external spacers.
<br clear=all>
[[File:IMG_4191_fixed_wiki.JPG|400px|right]]
'''2.''' Take 4 x ISO M2.5 screws (the smaller ones with round head).
<br clear=all>
[[File:capture000073_fixed_wiki.JPG|400px|right]]
[[File:capture000076_fixed_wiki.JPG|400px|right]]
'''3.''' Secure the display to the control board's top side using the 4 x small M2.5 screws. '''Don't tight the bolts yet!!!''' The display must be loose to get a good fit with the aluminum case top part. You will tight these screws later.
<br clear=all>
<br clear=all>