3,526
edits
Changes
Jump to navigation
Jump to search
Building a Zynthian Box using an official Kit (view source)
Revision as of 17:33, 16 January 2017
, 17:33, 16 January 2017→Connect the Controller Modules (x4)
Line 247:
Line 247:
[[File:zynthian_inside_01.jpg|600px]]+
−
So '''you should look at your controller modules from bottom side and with the pin-row on the top of PCB!'''
So '''you should look at your controller modules from bottom side and with the pin-row on the top of PCB!'''
−'''PHOTO NEEDED HERE!!'''
+'''PHOTO NEEDED HERE!!''' => detail controller connection
'''Note:''' Some encoders have reversed pin ordering, so, if you buy the encoders by yourself, perhaps you have to change A and B pins.
'''Note:''' Some encoders have reversed pin ordering, so, if you buy the encoders by yourself, perhaps you have to change A and B pins.
−'''PHOTO NEEDED HERE!!''' => controller connection in the case
−'''Warning:''' In this photo the controller modules wiring is reversed (1 by 2, 3 by 4). I will change it ASAP ;-)
===Connect the 2in1 Module===
===Connect the 2in1 Module===