159
edits
Changes
Jump to navigation
Jump to search
Line 239:
Line 239: − + + + + + + + + +
→Connecting the cables
|}
|}
=== Encoder ===
=== Controller ===
This is a little bit tricky. Depending on you setup it maybe useful to put the 6-pin-row on the back of the PCB. So you can front mount the encoders. I haven't done this: I used to bend the 6-pin-row by 90 degree. The original Zynthian does this not - so the counting is changed!
'''
Looking on the top of the PCB with the 6-pin-row down:
* Mounting the 6-pin-row on top of the PCB: Pin counting starts on the right of the row!
* Mounting the 6-pin-row on the back of the PCB: Pin counting starts on the left of the row!
'''
==== Controller 1 ====
==== Controller 1 ====