3,526
edits
Changes
Jump to navigation
Jump to search
Building a Zynthian Box using an official Kit (view source)
Revision as of 17:24, 16 January 2017
, 17:24, 16 January 2017→Controller Module 4-pin Dupont Wires (x 4)
Line 217:
Line 217:
'''PHOTO NEEDED HERE!!'''+
Take the 4 x "20cm 4-pin Dupont Connector Wires". These are used to connect the 4 controller modules to the RBPi GPIO:
Take the 4 x "20cm 4-pin Dupont Connector Wires". These are used to connect the 4 controller modules to the RBPi GPIO:
−[[File:Controller_dupont_wires.jpg|600px]]
You have to connect it to the middle male connector of the Ribbon Bus Cable following the next scheme:
You have to connect it to the middle male connector of the Ribbon Bus Cable following the next scheme: