Line 200:
Line 200:
=== TFT ===
=== TFT ===
+
+
Time for connecting thesuitable main-ribbon-cable with the (female) 40-pin-connector onto the Hifiberry. At the end of the cable is a (female) 26-pin-connector. This one must be connected onto the PiTFT. If you have a clone PiTFT which has no suitable port you have to solder one or use a gender changer. The original PiTFT has both versions of connector.
=== 2in1 ===
=== 2in1 ===
+
+
The 2in1-PCB must be connected using one of the mini-ribbon cables. The 6-pin connector must be located towards the PCB. Pin 1 is on the left bottom (component side up). On the other end of the cable are 1-pin female connectors. They must be connected onto the following pins on the (male) 40-pin-conenctor in the middle of the main-ribbon cable.
+
+
{| class="wikitable"
+
! Wire no. || Function || GPIO no. || Pin on Raspi no.
+
|-
+
| 1 || Vdc 3.3V || 3.3V || 1
+
|-
+
| 2 || RxD || RxD || 10
+
|-
+
| 3 || I2C SDA1 || 09 || 5
+
|-
+
| 4 || I2C SCL1 || 08 || 13
+
|-
+
| 5 || Vdc 5V || %v || 2/4
+
|-
+
| 6 || GND || GND || 6/9
+
|-
+
|}
+
+
Next connect the DIN socket (MIDI) onto the 2in1-PCB. The connector on the PCB is the 2-pin one located on the upper right of the PCB.
+
+
{| class="wikitable"
+
! Wire no. || Function || MIDI-IN pin no.
+
|-
+
| 1 || MIDI-IN-5 || 5 (MIDI connector: 2nd from left)
+
|-
+
| 2 || RxD || RxD || 4 (MIDI connector: 2nd from right)
+
|-
+
}
=== Encoder ===
=== Encoder ===