159
edits
Changes
Jump to navigation
Jump to search
Line 78:
Line 78: + + Line 93:
Line 95: − + − + + + + + + + + + + + + + + + + + +
no edit summary
|-
|-
| 24 || - || Short connector cables || Connector cables for MIDI and external GPIO connector from 2in1 board ||4|| ??,??
| 24 || - || Short connector cables || Connector cables for MIDI and external GPIO connector from 2in1 board ||4|| ??,??
|-
| 25 || - || Multi-pin connector || 1x40pol.-Stiftleiste, gerade, RM 2,54 ||1|| ??,??
|-
|-
|}
|}
You need:
You need:
* 1 * 2in1 PCB
* 1 * 2in1 PCB (Pos. 20)
* 2 * capacitor
* 2 * 100nF capacitor (Pos. 8)
* 1 * multi-pin 2 pins wide (part of Pos. 24)
* 1 * multi-pin 6 pins wide (part of Pos. 24)
* 1 * multi-pin 8 pins wide (part of Pos. 24)
* 1 * resistor 10 kOhm (brown-black-orange-gold, Pos. 7)
* 1 * resistor 1 kOhm (brown-black-red-gold, Pos. 6)
* 1 * resistor 220 Ohm (red-red-black-gold, Pos. 5)
* 1 * diode 1N4148 (Pos. 1)
* 1 * IC socket 8 pins (Pos. 10)
* 1 * IC socket 18 pins (Pos. 9)
* 1 * IC 6N138 (Pos. 2)
* 1 * IC MCP23008 (Pos. 15)
# Start with assembling the diode onto the PCB. Be careful to do this the right way - the small black (or white) stripe on one side of the diode must fit the same side of the white stripe on the PCB!
# After that solder the resistors.
# Then assemble the IC sockets, but do not put the ICs inside. We will do this at the end of this task.
# After that, solder the capacitors and the multi-pin-rows.
# Now insert the ICs into the socket. Be careful to put them weith the notch on the IC towards the hole of the white rectangle showing on the PCB!
=== Step 2: Encoder boards ===
=== Step 2: Encoder boards ===