25
edits
Changes
Jump to navigation
Jump to search
Line 28:
Line 28: + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + +
→Perfomix
This is, why for example there is a "Freq Min" and "Freq Max" knob in the "Low Pass" section. The minimum value represents the low pass filter frequency if the automation variable is 0 %, the maximum value represents the low pass filter frequency if it is 100 %.
This is, why for example there is a "Freq Min" and "Freq Max" knob in the "Low Pass" section. The minimum value represents the low pass filter frequency if the automation variable is 0 %, the maximum value represents the low pass filter frequency if it is 100 %.
Some effects behave different (see below in the details).
Some effects behave different (see below in the details).
For some effects you can choose a "Curve" or "Mod Curve" value. This is an exponent which influences the automation variable value. If you set this value to 1.0, the automation variable continuously changes from 0% to 100 %. If you set it to values smaller than 1.0, it rises fast from 0 % to higher values, but slowly reaches 100 % (fast change in the beginning of the build-up, slow change close to the end). If you set it to values higher than 1.0, it's the other way round - slow change at the beginning and fast change to the end.
== Detailed descriptions of every zynthian screen ==
=== Mixer screen ===
{|
|- style="vertical-align:center;"
|rowspan="4"|
[[File:Perfomix screens-01.png|frameless|center]]
||
Crossfader sets the Wet/Dry amount of original and effects audio.
If the value is higher than approx. 3 %, the build-up starts (looper too).
|-
||
Start or stop the build-up (and/or looper).
Equivalent to 100 % crossfading.
|-
||
If build-up style is set to "manual", this sets the internal automate variable.
|-
|| <br \>
|-
|}
=== Tempo screen ===
{|
|- style="vertical-align:center;"
|rowspan="4"|
[[File:Perfomix screens-02.png|frameless|center]]
||
This is only a proxy configuration and cannot be changed. It represents the host's tempo, but does not show the correct value.
|-
||
If the "Sync Host BPM" is set OFF, this sets the tempo of the looper, build-up counter, and also the tempo of the delay.
|-
||
Defaults to host's tempo setting (ON).
|-
|| <br \>
|-
|}
== Short tutorials ==
== Short tutorials ==