3,451
edits
Changes
Jump to navigation
Jump to search
Line 396:
Line 396: − − <br clear=all> − − [[File:capture000090_fixed_wiki.JPG|600px|right]] − − '''2.''' If you don't want your Zynthian V5 to behave like a rattle, please, remove the nuts and rings from the rotary encoders. You don't need these, so you can throw them away or keep them in the screws tray. Line 407:
Line 401: − + Line 413:
Line 407: − +
Assembling Zynthian Kit V5.1 (view source)
Revision as of 16:59, 16 September 2024
, 16:59, 16 September 2024→Secure the top-spacers on the control board
'''1.''' Take the control board from its case. You don't need the silicone buttons yet.
'''1.''' Take the control board from its case. You don't need the silicone buttons yet.
<br clear=all>
<br clear=all>
[[File:capture000071_fixed_wiki.JPG|600px|right]]
[[File:capture000071_fixed_wiki.JPG|600px|right]]
'''3.''' Take the 8 x brass spacers 10mm and 8 x ISO7380 M3 screws (the mid-size ones with round head).
'''2.''' Take the 8 x brass spacers 10mm and 8 x ISO7380 M3 screws (the mid-size ones with round head).
<br clear=all>
<br clear=all>
[[File:capture000068_fixed_wiki.JPG|600px|right]]
[[File:capture000068_fixed_wiki.JPG|600px|right]]
'''4.''' Secure the 8 x spacers on the control board's top side. To do this, insert the bolt from the back side and while holding it with your finger, fasten the spacer with the other hand until it's tight. You don't need a wrench for this, but you can use one if you like.
'''3.''' Secure the 8 x spacers on the control board's top side. To do this, insert the bolt from the back side and while holding it with your finger, fasten the spacer with the other hand until it's tight. You don't need a wrench for this, but you can use one if you like.
<br clear=all>
<br clear=all>