Changes

<br clear=all>

<br clear=all>

[[File:IMG_4282_fixed_wiki.JPG|600px|right]]

[[File:build51_sdcard_adapter_01.jpg|600px|right]]

'''2.''' Carefully, using 2 fingers, one on each hand, pull the main board's SD-card connector tongue until it's totally open.

'''2.''' Carefully, using 2 fingers, one on each hand, pull the main board's SD-card connector tongue until it's totally open.

<br clear=all>

<br clear=all>

[[File:IMG_4286_fixed_wiki.JPG|600px|right]]

[[File:build51_sdcard_adapter_02.jpg|600px|right]]

'''3.''' Insert the SD-card adapter's ribbon cable. It must be inserted straight, with the blue side facing down.

'''3.''' Insert the SD-card adapter's ribbon cable. It must be inserted straight, with the blue side facing down.

<br clear=all>

<br clear=all>

[[File:IMG_4289_fixed_wiki.JPG|600px|right]]

[[File:build51_sdcard_adapter_03.jpg|600px|right]]

'''4.''' When it's totally inserted, push the tongue with 2 fingers at once and close the connector. Pay attention to ensure the cable does not move out of the connector. If it's not well inserted or not straight, repeat the operation until it's OK.

'''4.''' When it's totally inserted, push the tongue with 2 fingers at once and close the connector. Pay attention to ensure the cable does not move out of the connector. If it's not well inserted or not straight, repeat the operation until it's OK.

<br clear=all>

<br clear=all>

[[File:IMG_4296_fixed_wiki.JPG|600px|right]]

[[File:build51_sdcard_adapter_04.jpg|600px|right]]

'''4.''' Plug the SD-card adapter into the RPI4's SD-card holder.

'''5.''' Plug the SD-card adapter into the RPI5's SD-card holder. The connector is at 90º, so you must softly bend the ribbon cable to get it plugged-in. Check the pictures and proceed slowly, always using the minimum amount of force.

<br clear=all>

<br clear=all>