Changes

<br clear=all>

<br clear=all>

[[File:IMG_4188_fixed_wiki.JPG|600px|right]]

[[File:build51_rpi5_thermal_finished.jpg|600px|right]]

'''8.''' Finally, stick the remaining piece of thermal pad (27 x 20 mm) on the contact surface in the external side of the thermal block. That is, on top of the "tower" with 2 tiny holes. Follow the same procedure you already did with the 3 smaller pieces, but don't remove the transparent protective sheet yet. This will be done later, when installing the module in the aluminum case bottom.

'''8.''' Finally, stick the remaining piece of thermal pad (27 x 20 mm) on the contact surface in the external side of the thermal block. That is, on top of the big "tower" with 2 tiny holes. Follow the same procedure you already did with the 3 smaller pieces, but don't remove the protective sheet yet. This will be done later, when installing the module in the aluminum case bottom.

<br clear=all>

<br clear=all>