3,451
edits
Changes
Jump to navigation
Jump to search
Line 214:
Line 214: + + + + + + + − +
Assembling Zynthian Kit V5.1 (view source)
Revision as of 14:40, 14 September 2024
, 14:40, 14 September 2024→Install the thermal block
<br clear=all>
<br clear=all>
[[File:build51_rpi5_thermal_display_cable_bending_01.jpg|600px|right]]
[[File:build51_rpi5_thermal_display_cable_bending_02.jpg|600px|right]]
[[File:build51_rpi5_thermal_display_cable_bending_03.jpg|600px|right]]
[[File:build51_rpi5_thermal_display_cable_bending_04.jpg|600px|right]]
'''7.''' Before installing the "RPi5 + thermal block" assembly in the main board, you must bend the display cable adequately, so it goes in the right direction. You must bend it twice, putting attention to the pictures and using your "common sense". Indeed, it's not difficult if you already did it, but as it's probably the first time, you could have doubts. Look at the pictures and use the zoom until you have clear how to proceed.
[[File:IMG_4188_fixed_wiki.JPG|600px|right]]
[[File:IMG_4188_fixed_wiki.JPG|600px|right]]
'''7.''' Finally, stick the remaining piece of thermal pad (27 x 20 mm) on the contact surface in the external side of the thermal block. That is, on top of the "tower" with 2 tiny holes. Follow the same procedure you already did with the 3 smaller pieces, but don't remove the transparent protective sheet yet. This will be done later, when installing the module in the aluminum case bottom.
'''8.''' Finally, stick the remaining piece of thermal pad (27 x 20 mm) on the contact surface in the external side of the thermal block. That is, on top of the "tower" with 2 tiny holes. Follow the same procedure you already did with the 3 smaller pieces, but don't remove the transparent protective sheet yet. This will be done later, when installing the module in the aluminum case bottom.
<br clear=all>
<br clear=all>