3,451
edits
Changes
Jump to navigation
Jump to search
Line 78:
Line 78: − + − + − + − + +
Supported plug & play MIDI controllers (view source)
Revision as of 00:31, 22 January 2024
, 00:31, 22 January 2024→ZynMixer driver
Chains are numbered from left to right as shown in the zynmixer screen. Note that these numbers are not MIDI channels!
Chains are numbered from left to right as shown in the zynmixer screen. Note that these numbers are not MIDI channels!
* '''Bank Left:''' Select chains 1-8
* '''Bank Left:''' Strips assigned to chains 1-8
* '''Bank Right:''' Select chains 9-16
* '''Bank Right:''' Strips assigned to chains 9-16
* '''Master Fader:''' Main volume
* '''Master Fader:''' Main volume
* '''Control Strip 1-8:''' Chain control, depending of bank selection
* '''Strip 1-8:''' Chain's mixer control, depending of bank selection
** '''Upper Knobs:''' The 2 upper knobs are available for MIDI learning.
** '''Upper Knobs:''' The 2 upper knobs are available for MIDI learning.
** '''Lower Knob:''' Chain's balance
** '''Lower Knob:''' Chain's balance
** '''Mute:''' Chain's solo switch
** '''Mute:''' Chain's solo switch
** '''Solo''': Push <code>SOLO</code> to see solo status. Push <code>SOLO</code> + <code>MUTE</code> for toggling solo.
** '''Solo''': Push <code>SOLO</code> to see solo status. Push <code>SOLO</code> + <code>MUTE</code> for toggling solo.
** '''Rec Arm''': Red light indicates active chain. Push to set active chain.
** '''Fader:''' Chain's volume
** '''Fader:''' Chain's volume