Line 148:
Line 148:
[[File:Encoder_Solo.jpg|600px]]
[[File:Encoder_Solo.jpg|600px]]
+
+
Alternative: Mount the pin row at the bottom of the PCB:
+
+
[[File:Encoder-Pins-Down.jpg|600px]]
=== Step 3: Pin row on the Hifiberry ===
=== Step 3: Pin row on the Hifiberry ===
Line 242:
Line 246:
=== Controller ===
=== Controller ===
−
This is a little bit tricky. Depending on you setup it maybe useful to put the 6-pin-row on the back of the PCB. So you can front mount the encoders. I haven't done this: I used to bend the 6-pin-row by 90 degree. The original Zynthian does this not - so the counting is changed!
+
This is a little bit tricky. Depending on you setup it maybe useful to put the 6-pin-row on the back of the PCB. So you can front mount the encoders. I haven't done this: I used to bend the 6-pin-row by 90 degree. The original Zynthian does this not - so the pin counting is changed!
'''Looking on the top of the PCB with the 6-pin-row down:'''
'''Looking on the top of the PCB with the 6-pin-row down:'''
−
* Mounting the 6-pin-row on top of the PCB: Pin counting starts on the right of the row!
+
* Mounting the 6-pin-row on top of the PCB: Pin counting starts on the left of the row!
−
* Mounting the 6-pin-row on the back of the PCB: Pin counting starts on the left of the row!
+
* Mounting the 6-pin-row on the back of the PCB: Pin counting starts on the right of the row!
+
+
There some encoders that has reversed the pin order, so you have to change A and B pins.
==== Controller 1 ====
==== Controller 1 ====