3,418
edits
Changes
Jump to navigation
Jump to search
Line 450:
Line 450: − − =Final steps= − − Once everything is in its place and you have tested that it works, it's time to close the case − − − ===Close the case=== − − Take your time to bend and push the cables to get a good fit when closing the case. The ribbon bus cable is pre-bent to make this process easier. − − − [[File:IMG_3126_OK_1024.JPG|600px]] − − − Finally, fasten the 8 self-taping bolts to secure the case, 4 on each side. − − − [[File:IMG_3148_OK_1024.JPG|800px]] − − {{NoteBox| Be careful not to over-tighten the case screws, as it can buckle the top plate. If you notice the top place bowing slightly, loosen the screws a little until the surface is level. }}
Building a Zynthian Box using official Kits v4.2-v4.6 (view source)
Revision as of 13:14, 8 November 2021
, 13:14, 8 November 2021→Final steps
If this doesn't work, you have to [[#Locating_and_Solving_problems|locate and solve the problem(s)]].
If this doesn't work, you have to [[#Locating_and_Solving_problems|locate and solve the problem(s)]].
=Update your Zynthian Box=
=Update your Zynthian Box=