88
edits
Changes
Jump to navigation
Jump to search
Building a Zynthian Box using an official Kit v3 (view source)
Revision as of 11:38, 13 January 2020
, 11:38, 13 January 2020→Final steps
Line 425:
Line 425:
=Final steps=
=Final steps=
−Once everything is in its place and you have tested that it works, it's time to close the case ...
+Once everything is in its place and you have tested that it works, it's time to close the case
===Close the case===
===Close the case===
−Take your time to see how to bend and drive the cables to get a good fitting when closing the case. The ribbon bus cable is pre-bended for easing this process.
+Take your time to bend and push the cables to get a good fit when closing the case. The ribbon bus cable is pre-bent to make this process easier.
Line 435:
Line 435:
−Finally, screw-drive the 8 sheet-threader bolts for securing the case, 4 each side.
+Finally, fasten the 8 sheet-threaded bolts to secure the case, 4 on each side.