2,705
edits
Changes
Building a Zynthian Box using an official Kit v3 (view source)
Revision as of 20:24, 17 July 2019
, 20:24, 17 July 2019→Locating and Solving problems
In this section i will try to give you some tips for locating and solving the problems you may have.
In this section i will try to give you some tips for locating and solving the problems you may have.
For finding and solving problems, i really recommend to connect a HDMI display to the RBPi. It will give you accurate information during the booting sequence. Also, if you connect a USB keyboard, you can login into the system and get extra information, inspect the logs, etc.
For finding and solving problems, i really recommend to connect a HDMI display to the RBPi. It will give you accurate information during the booting sequence. Also, if you connect an USB keyboard, you could login into the system and get extra information, inspect the logs, etc.
===The display don't go white in the boot stage 1===
===The display don't show the zynthian splash screen on boot===
In that case, probably the system is not booting correctly. You could try to connect a HDMI display and see if the system is booting. If you can't see the booting sequence, then you should re-burn your SD-card with the Zynthian image. Also, check that your image file is correct by using the SHA1 signature.
If the problem persist it's very probable you haven't solder correctly the side 26-pin connector. You should double check the connector and be sure that it's correctly soldered.
===You get the zynthian error screen with the IP==
Your hardware seems to be incorrectly configured. You should access the webconf tool and configure your hardware.
===The display don't show the zynthian splash screen in the boot stage 2===
==Your controllers doesn't work==
You make a mistake while connecting the controllers or your hardware (wiring layout) is incorrectly configured. You should access the webconf tool and configure your hardware.
'''More coming soon ...'''
'''More coming soon ...'''