Open main menu
Home
Random
Log in
Settings
About ZynthianWiki
Disclaimers
Search
Changes
← Older edit
Newer edit →
Building a Zynthian Box using an official Kit v2
(view source)
Revision as of 10:15, 18 October 2017
421 bytes added
,
10:15, 18 October 2017
→Assembling the All-In-One Module
Line 217:
Line 217:
[[File:2in1_kit.jpg|600px]]
[[File:2in1_kit.jpg|600px]]
−
These are the steps for building the
2in1
module:
+
These are the steps for building the
All-In-One
module:
0. Be sure that you have read and understood [[#Some_general_recommendations|these recommendations]].
0. Be sure that you have read and understood [[#Some_general_recommendations|these recommendations]].
−
1. Place
all
the components in the upside of the PCB (the labeled side!)
. Put attention to the orientation of the ICs and diodes
.
+
1. Place the
passive
components
(resistors & capacitors)
in the upside of the PCB (the labeled side!).
2. Solder the components carefully. Always avoid overheating!
2. Solder the components carefully. Always avoid overheating!
+
3. Place the ICs and diodes in the upside of the PCB (the labeled side!). Put attention to the orientation of these components!!
+
4. Solder the components carefully. Always avoid overheating! (*)
+
5. Place the connectors in the upside of the PCB (the labeled side!).
+
6. Solder the components carefully. Always avoid overheating! (*)
+
+
(*) You could use some tape for fixing the components while soldering, specially for ICs and connectors.
[[File:2in1_ensambled.jpg|600px]]
[[File:2in1_ensambled.jpg|600px]]
Jofemodo
Bureaucrats
,
Interface administrators
,
Suppressors
,
Administrators
2,719
edits