Zynthian TODO list
1 BUGS
- Set correct values when loading a Carla patch. Wait to receive all information of each CC (jofemodo)
2 SOFTWARE DEVELOPMENT
- Feedback Controller Values from Synthesizer (initial loading) => Done for Carla, pending for ZASFX and others (jofemodo)
- Improve Carla Integration => MIDI channels, MIDI routing, Loading patches without restarting engine. (jofemodo)
- Improve Dexed Integration => Bank Selection / Instrument Names
- Web Interface => WIFI config, ...
- mod-host/mod-gui integration (holger)
- Show CPU and RAM usage on display
- VU-meter on display
- SD card read-only implementation => testing (holger)
- Adding support for external controllers (MIDI/OSC/...)
- Compiling and Testing a RT kernel (holger)
- Script which resizes the SD card after installation automaticly (holger)
- Allow several standalone synth engines: full multi-timbric! (jofemodo)
- Synth Engine integration: PureData
- Synth Engine integration: CSound
- Synth Engine integration: SuperCollider
- Synth Engine integration: ???
3 HARDWARE DEVELOPMENT
- Improve 2in1 circuit, add MIDI-OUT & MIDI-THROU
- Headphones circuit
- Audio Input (ADC)
- Balanced Audio Outputs
- Leds for MIDI-IN, AUDIO-OUT, etc.
- New 2 in 1 pcb with simple connections and cables reduction (paulfalduto)
4 CASE DEVELOPMENT
- Finish New Aluminium Case: serigraphy design, side bolts
- Fix/Improve 3D Printing Box Design (paulfalduto)
- Bolt holes for 2in1 circuit
- The top is too thick and can't screw the nuts in the rotary encodern. Change the top design to be a little thinner.
- The screen rectangle is too big and you see the "ugly" part of screen. Using the original size would be nicer. Also, perhaps can give some angle to the screen border to minimize shadow when looking from the side.
- The Zynthian logo in the top is missing
- The external bolt supports should not be 90º in the down side
- Fix surface defects
- Lasser Cutter Dessign (for wood/metacrilat)
5 DOCUMENTATION
- Improve User's Guide (jofemodo)