===The display don't go white in the boot stage 1===
===The display don't go white in the boot stage 1===
−
In that case it's very probable you haven't solder correctly the side 26-pin connector. You should double check
+
+
I recommend you disconnect the controller and 2in1 modules and try to boot again.
+
If the problem persist it's very probable you haven't solder correctly the side 26-pin connector. You should double check the connector and be sure that it's correctly soldered.
+
+
===The display don't show the zynthian splash screen in the boot stage 2===
+
+
In that case, probably the system is not booting correctly. You could try to connect a HDMI display and see if the system is booting. If you can't see the booting sequence, then you should re-burn your SD-card with the Zynthian image. Also, check that your image file is correct by using the SHA1 signature.