Changes

Building Zynthian MINI V2 (view source)

Revision as of 10:16, 6 May 2024

6 bytes removed , 6 May

→‎Assembling all parts into 3D printed case: Fixed numbering

Line 362: Line 362:

6. screws for brass heat set inserts (quanity 8) - M2.5, 6mm - can be purchased [https://www.aliexpress.com/item/4001248931159.html here]

7. 5" DSI screen and its screws - can be purchased [https://github.com/sstojos/zynthian-mini/wiki/V2-Components-required here]

−

8. zynthian MINI V2 PCB - check instructions above how to assemble it

+

8. zynthian MINI V2 PCB - check instructions above how to assemble it

−

9. enncoder caps (quantity 4) and nuts - check PCB components required above where to buy it

+

9. enncoder caps (quantity 4) and nuts - check PCB components required above where to buy it

10. Neutrik 1/4 stereo connector cap - can be purchased [https://github.com/sstojos/zynthian-mini/wiki/V2-Components-requiredhere]

−

11. raspberry pi 4 with heatsink

+

11. raspberry pi 4 with heatsink

−

12. raspbery pi posts and their screws

+

12. raspbery pi posts and their screws - their size depend on heatsink - the standard zynthian MINI V2 PCB build recommends two spacers connector which is 16mm long so that there is enough space for raspberry pi to cool - therefore if heatsink is 7mm then raspberry pi posts need to be 9mm (7mm+9mm=16mm)

−

*their size depend on heatsink - the standard zynthian MINI V2 PCB build recommends two spacers connector which is 16mm long so that there is enough space for raspberry pi to cool - therefore if heatsink is 7mm then raspberry pi posts need to be 9mm (7mm+9mm=16mm)

+

13. HAT posts (quantity 4) - 11mm standard.

−

13. HAT posts (quantity 4) - 11mm standard.

14. Tools required - soldering iron for inserting heat set inserts and small phillips screw driver

Stojos

59

edits