Changes

To set the channel that ZynSeq listens for triggers, select ''Trigger channel'' from the menu.

To set the channel that ZynSeq listens for triggers, select ''Trigger channel'' from the menu.

Each sequence may be triggered by a MIDI note. Select "Trigger note" from the menu to adjust the MIDI note that will trigger the highlighted pad. By default triggers are disabled. To disable a sequence from being triggered set its trigger value to None which is below C-1 or above G9, i.e. increase to maximum value.

Each sequence may be triggered by a MIDI note. Select "Trigger note" from the menu to adjust the MIDI note that will trigger the highlighted pad. Note may be selected with the SELECT encoder or by playing a note on an external controller on the MIDI trigger channel. By default triggers are disabled. To disable a sequence from being triggered set its trigger value to None which is below C-1 or above G9, i.e. increase to maximum value.

ZynSeq will send MIDI note on messages to represent the current play status of each sequence with play state represented by MIDI note velocity. This may be used by an external pad controller like Novation's Launchpad to indicate the status of a sequence. The note number sent is the same as the external trigger configured for a sequence. Tallies are sent on the same MIDI channel as configured to receive triggers. Currently only the following tallies are configured which will work with Akai APC:

ZynSeq will send MIDI note on messages to represent the current play status of each sequence with play state represented by MIDI note velocity. This may be used by an external pad controller like Novation's Launchpad to indicate the status of a sequence. The note number sent is the same as the external trigger configured for a sequence. Tallies are sent on the same MIDI channel as configured to receive triggers. Currently only the following tallies are configured which will work with Akai APC: