Open main menu
Home
Random
Log in
Settings
About ZynthianWiki
Disclaimers
Search
Changes
← Older edit
Newer edit →
Building a Zynthian Box using an official Kit
(view source)
Revision as of 21:37, 9 July 2017
24 bytes added
,
21:37, 9 July 2017
→Controller Module 4-pin Dupont Wires (x 4)
Line 343:
Line 343:
====Controller Module 4-pin Dupont Wires (x 4)====
====Controller Module 4-pin Dupont Wires (x 4)====
+
+
The next scheme shows the numbering/naming used for encoders and switches:
+
+
[[File:zynthian_ui_legend.png]]
Take the 4 x "20cm 4-pin Dupont Connector Wires". These wires are used to connect the 4 controller modules to the RBPi GPIO:
Take the 4 x "20cm 4-pin Dupont Connector Wires". These wires are used to connect the 4 controller modules to the RBPi GPIO:
Line 355:
Line 359:
'''Note:''' While connectig the wires, the red wire of the Main Ribbon Bus must be at left. The red wire is ALWAYS the #1!
'''Note:''' While connectig the wires, the red wire of the Main Ribbon Bus must be at left. The red wire is ALWAYS the #1!
−
−
This scheme shows the switches numbering & naming:
−
−
[[File:zynthian_ui_legend.png]]
====2in1 Module 6-pin Dupont Wire====
====2in1 Module 6-pin Dupont Wire====
Jofemodo
Bureaucrats
,
Interface administrators
,
Suppressors
,
Administrators
2,718
edits