2,703
edits
Changes
Jump to navigation
Jump to search
Line 323:
Line 323: + + + + + + + + + + + + + + + + +
Building a Zynthian Box using official Kits v4.2-v4.6 (view source)
Revision as of 13:15, 8 November 2021
, 13:15, 8 November 2021→Connect the Display
'''And that's all!!''' Your Zynthian Box is almost ready to boot. I recommend that you double-check everything before powering up the device.
'''And that's all!!''' Your Zynthian Box is almost ready to boot. I recommend that you double-check everything before powering up the device.
===Close the case===
Once everything is in its place and you have tested that it works, it's time to close the case
Take your time to bend and push the cables to get a good fit when closing the case. The ribbon bus cable is pre-bent to make this process easier.
[[File:IMG_3126_OK_1024.JPG|600px]]
Finally, fasten the 8 self-taping bolts to secure the case, 4 on each side.
[[File:IMG_3148_OK_1024.JPG|800px]]
{{NoteBox| Be careful not to over-tighten the case screws, as it can buckle the top plate. If you notice the top place bowing slightly, loosen the screws a little until the surface is level. }}
=Testing your Zynthian Box=
=Testing your Zynthian Box=