Changes

Jump to navigation Jump to search
Line 450: Line 450:     
If this doesn't work, you have to [[#Locating_and_Solving_problems|locate and solve the problem(s)]].
 
If this doesn't work, you have to [[#Locating_and_Solving_problems|locate and solve the problem(s)]].
  −
=Final steps=
  −
  −
Once everything is in its place and you have tested that it works, it's time to close the case
  −
  −
  −
===Close the case===
  −
  −
Take your time to bend and push the cables to get a good fit when closing the case. The ribbon bus cable is pre-bent to make this process easier.
  −
  −
  −
[[File:IMG_3126_OK_1024.JPG|600px]]
  −
  −
  −
Finally, fasten the 8 self-taping bolts to secure the case, 4 on each side.
  −
  −
  −
[[File:IMG_3148_OK_1024.JPG|800px]]
  −
  −
{{NoteBox| Be careful not to over-tighten the case screws, as it can buckle the top plate. If you notice the top place bowing slightly, loosen the screws a little until the surface is level. }}
      
=Update your Zynthian Box=
 
=Update your Zynthian Box=

Navigation menu