Changes

The ZynAuCon module improves and simplifies the audio wiring by using a small ribbon cable for driving the 4 balanced channels (2 inputs + 2 outputs) to the 4 high-quality Neutrik TSR case-connectors. For mounting the ZynAuCon, secure the 2 x 15mm separators with 2 x black-anodized bolts M2.5. Next, you have to insert the board from inside the case and secure them with the 4 x nuts from the outside. Use a wrench for tightening the nuts, but not too much, and take care of not damaging the surface of the nice aluminum case!!

The ZynAuCon module improves and simplifies the audio wiring by using a small ribbon cable for driving the 4 balanced channels (2 inputs + 2 outputs) to the 4 high-quality Neutrik TSR case-connectors. For mounting the ZynAuCon, secure the 2 x 15mm separators with 2 x black-anodized bolts M2.5. Next, you have to insert the board from inside the case and secure them with the 4 x nuts from the outside. Use a wrench for tightening the nuts, but not too much, and take care of not damaging the surface of the nice aluminum case!!

[[File:IMG_2886_OK_1024.JPG|400px]]

[[File:IMG_3419_fixed.JPG|200px]]

[[File:IMG_2896_OK_1024_fixv41.JPG|400px]]

[[File:IMG_3355_fixed.JPG|400px]]

[[File:IMG_2898_OK_1024.JPG|400px]]

[[File:IMG_3387_fixed.JPG|400px]]

 

[[File:IMG_3395_fixed.JPG|400px]]

[[File:IMG_3401_fixed2.JPG|500px]]

===Secure the MIDI connectors===

===Secure the MIDI connectors===

{{NoteBox|The Hifiberry DAC+ADC Stage may include some nylon spacers and bolts. You can choose to use these instead of the metal ones included with the Zynthian kit. }}

{{NoteBox|Note that the "Hifiberry DAC+ADC Stage", included in the 4.1, 4.2 & 4.3 kits, and the "ZynADAC", included in the 4.4 kit, have no RCA connectors. Photos may show an older model, but these instructions are accurate for 4.1 to 4.4 kits. }}

 

{{NoteBox|Note that the Hifiberry DAC+ADC Stage included in the 4.1 kit has no RCA connectors. Photos may show an older model, but these instructions are accurate for V4.1. }}

===Secure the Zynaptik module===

===Secure the Zynaptik module===

Plug the little 2x10 ribbon cable on the Hifiberry's J1 connector. Next, plug the other end on the ZynAuCon board. Observe that the ribbon cable must be bent forming a 90º angle, so it fits perfectly the space and distance between the 2 IDC connectors.  

Plug the little 2x10 ribbon cable on the Hifiberry's J1 connector. Next, plug the other end on the ZynAuCon board. Observe that the ribbon cable must be bent forming a 90º angle, so it fits perfectly the space and distance between the 2 IDC connectors.  

[[File:HifiBerryDACADC-Stage-connection-OUT.png|600px]]

 

[[File:IMG_3410_fixed.JPG|600px]]

 

FYI, this is the specification for the 10-pin header (J1) on the Hifiberry DAC+ADC Stage:

FYI, this is the specification for the 10-pin header (J1) on the Hifiberry DAC+ADC Stage: