2,718
edits
Changes
Building a Zynthian Box using an official Kit (view source)
Revision as of 17:39, 17 January 2017
, 17:39, 17 January 2017→Clonic TouchScreen
After removing the female connector, the side connector must be soldered. Note that you have to place it on the bottom side of the board, so you should solder the contacts on the top side.
After removing the female connector, the side connector must be soldered. Note that you have to place it on the bottom side of the board, so you should solder the contacts on the top side.
'''WARNING!''' Soldering the 26-pin connector can be difficult if you don't have enough practice. Please, before starting be sure that you have readed and understanded [[#Some_general_recommendations|this recommendations]].
'''WARNING!''' Soldering the 26-pin connector can be difficult if you don't have enough practice. Please, before starting be sure that you have readed and understanded [[#Some_general_recommendations|these recommendations]].
[[File:Pitft_clonic_touchscreen_unassambled.jpg|600px]]
[[File:Pitft_clonic_touchscreen_unassambled.jpg|600px]]