2,718
edits
Changes
Building a Zynthian Box using an official Kit (view source)
Revision as of 17:34, 17 January 2017
, 17:34, 17 January 2017→Clonic TouchScreen
[[File:Clonic_pitft_tweaked_connectors.jpg|600px]]
[[File:Clonic_pitft_tweaked_connectors.jpg|600px]]
Frequently, clonic PiTFT touchscreen have soldered 4 switches that could be annoying when mounting the display in the case. If the switches remain pressed after mounting, then it would certainly cause problems as it uses GPIO pins and will conflict with the controller modules. The switches are easily pulled out with a pair of pliers, rotating each switch parallel to the board.
Frequently, clonic PiTFT touchscreen have 4 switches soldered on it. This switches can be annoying when holding the display to the case. If the switches remain pressed after mounting, then it will cause problems as are connected to the GPIO pins and will conflict with the controller modules. The switches are easily pulled out, slighty rotating each switch parallely to the board with a pair of pliers.
[[File:Pitft_clonic_touchscreen_switches.jpg|600px]]
[[File:Pitft_clonic_touchscreen_switches.jpg|600px]]