Open main menu
Home
Random
Log in
Settings
About ZynthianWiki
Disclaimers
Search
Changes
← Older edit
Newer edit →
Building a Zynthian Box using an official Kit
(view source)
Revision as of 12:45, 17 January 2017
41 bytes added
,
12:45, 17 January 2017
→Assembling the Controller Modules
Line 150:
Line 150:
1. Bend the encoder's securing tabs to 90º, so you can insert it in the upside of the PCB (the labeled side!).
1. Bend the encoder's securing tabs to 90º, so you can insert it in the upside of the PCB (the labeled side!).
2. Place the capacitor in the C1 position (the most right!)
2. Place the capacitor in the C1 position (the most right!)
−
3. Solder the encoder and capacitor carefully.
Always avoid
overheating!
+
3. Solder the encoder and capacitor carefully.
Avoid
overheating!
=> [[#Some_general_recommendations|Read this!]]
4. Place the pin-row connector in the downside of the PCB, with the angle pins facing inwards (look the photo!)
4. Place the pin-row connector in the downside of the PCB, with the angle pins facing inwards (look the photo!)
5. Solder the pin-row carefully.
5. Solder the pin-row carefully.
Jofemodo
Bureaucrats
,
Interface administrators
,
Suppressors
,
Administrators
2,718
edits