2,718
edits
Changes
Jump to navigation
Jump to search
Line 295:
Line 295: − + Line 307:
Line 307: − + Line 315:
Line 315: − +
Building a Zynthian Box using an official Kit (view source)
Revision as of 17:55, 17 January 2017
, 17:55, 17 January 2017→Connect the Dupont Wires to the Main Ribbon Bus
[[File:wiring_scheme_controllers_single.png|600px]]
[[File:wiring_scheme_controllers_single.png|600px]]
'''Note:''' The red wire of the Main Ribbon Bus must be at left. This wire is ALWAYS the #1!
'''Note:''' While connectig the wires, the red wire of the Main Ribbon Bus must be at left. The red wire is ALWAYS the #1!
====2in1 Module 6-pin Dupont Wire====
====2in1 Module 6-pin Dupont Wire====
[[File:Cable-schema-2in1.png|600px]]
[[File:Cable-schema-2in1.png|600px]]
'''Note:''' The red wire of the Main Ribbon Bus must be at left. This wire is ALWAYS the #1!
'''Note:''' While connectig the wires, the red wire of the Main Ribbon Bus must be at left. The red wire is ALWAYS the #1!
In that point you should have something like this:
In that point you should have something like this:
====Connect the Main Ribbon Bus to the RBPi====
====Connect the Main Ribbon Bus to the RBPi====
It's time to connect the Main Ribbon Bus to the RBPi GPIO. The red wire must be in the left, like the photo:
It's time to connect the Main Ribbon Bus to the RBPi GPIO. When looking to the case from the front side, the red wire must be in the right, like in the photo:
'''PHOTO NEEDED HERE!!'''
'''PHOTO NEEDED HERE!!'''