1,019
edits
Changes
→Encoders directly connected to GPIO Pins
Line 449:
Line 449:
This is the original approach used from the start the Encoder were connected directly to GPIO pins on the Raspberry Pi. It is not considered as the recommended approach.
This is the original approach used from the start the Encoder were connected directly to GPIO pins on the Raspberry Pi. It is not considered as the recommended approach.
−Please see the 23017 approach described below.
+Please see the 23017 approach described above.
[[File:Zynthian-amp3-open.jpg|300px|frame|center|Zynthian-amp3-open]]
[[File:Zynthian-amp3-open.jpg|300px|frame|center|Zynthian-amp3-open]]